Flat spiral or Millipede bead design
 Flat spiral or Millipede bead design

Materials:

Crytsal beads, sed beads or cone beads

Use a  size 8cb and size 1sb or 2sb, or replace the crystal bead with a  conebead

Procedure:
Step 1: Use 1sb as a stopper

Step 2: pick 2cb, 4sb, 1conebead and 4sb and pass ur fl from the bottom into d 2cb
Step 3: pick 3sb, 1conebead and 3sb and pass ur fl into the same 2cb
Step 4: pick 1cb, 4sb, 1conebead and 4sb pass ur fl into 1cb in step 2 and the 1cb u just added, making 2cb altogether
Step 5: pick 3sb, 1conebead and 3sb and pass into d 2cb again.

Continue repeating step 4 and 5 till you get your desired length
Tip: Make sure the  side in which  you are picking 3sb all lay in one side and the 4sb too lay in one side. Don’t mix them up. As the work progresses, the project will curve on its own.
Altenatively, use all seedbeads, a size 10 sb and 8sb will suffix.


via Blogger http://ift.tt/2cAAGuF

Advertisements